How to Use
Design and Print
The design it self should have a high
resolution 0f at least 300dpi. This is
necessary for quality printing .
Saturated blacks and high contrast will
give better detailed stencil results
Printing the design using the “high quality“ and “color” options in the printing definitions .
Skin Application
Here is our advice for a successful application :
1. Sanitize the skin- rubbing alcohol 70% only! This is to neutralize the skin oils and ph level and allow the stencil to transfer well to the skin.
2. Transfer Gel- When dry again apply transfer solution gel of your choice. (you can find our client's recommended brands on the FAQ's page).
Itis very important to find the right amount of solution, for an accurate transfer. Because the printer stencil is different then
a thermal or hand tracing stencil, it may take a few tries to get it right.
3. Application- Apply the stencil on the skin and press it
down. you can use a paper towel damp with some rubbing alcohol. This disconnect the ink from the paper on to the skin.
4. Drying- Remove the stencil Paper and let the stencil on the skin to dry for at least 10 minutes. To ensure that the stencil will stay strong and durable throughout the tattooing process.
Enjoy!
How To Use
Canon PIXMA setup
Follow the Canon instructions manual and set up the printer.
Carfully remove the protective clip and insert the Perfect Stencil cartridges at the proper stage of the setup.
Keep the clips for resealing of the catridges, should you choose to switch between stencil and normal printing.
Enjoy.
Printing instructions for Canon
Standart / High quality print
The printed design should be at standard print quality of minimum 300 dpi
Epson eco tank setup
Follow the Epson paper instructions manual , not through the App
- Make sure to fill the tank all the way to the top
- Let each step of the process finish properly
- lLoad standard printing paper in the tray for the test print
-Run the head cleaning process after the nozzle check, as advised in the instructions.
- After the head cleaning, install the Epson Smart Panel App and connect the printer to the Wi-Fi For your printing:
-Load one stencil paper sheet on top of the standard paper, to avoid paper jams
- Make sure your design is in high resolution and has saturated blacks
Printing definitions on the Epson eco tank
1.see that the paper type is - “glossy paper”
2. Choose Color printing
3. Printing quality- “high”
Stencil design and printing
-Make sure your design is in high resolution and has saturated blacks and good contrast.
Load one stencil paper sheet on top of the standard paper, to avoid paper jams
Print your design using the recommended printing definitions.
VECTOR -stencil liner
Prepare your client's skin, as you would for any stencil application.
Using gloves- Pull out the stencil thread SLOW, until you get your desired leght.
Cut.
Hold straight with 2 hands and mark the skin to your liking.
Apply your designed stencil using you VECTOR liner markings as guides
Let dry for 10 min.
Enjoy!
Share and get 15% off!
Simply share this product on one of the following social networks and you will unlock 15% off!